This universal garage door remote control kit connects directly to your existing push button or controller, giving you a simple and reliable way to upgrade your system without replacing the motor. It’s fully expandable too, allowing you to add extra remotes whenever needed.

Key Features:

Universal Compatibility – Works with any garage door system that has a low-voltage push button or start terminal, making it a true universal garage door remote solution.
Pre-wired Receiver – Supplied with 3 metres of pre-wired cable for quick, clean installation directly into your current setup.
2-Channel Receiver – Suitable for single or dual garage doors, featuring support for 3-wire inputs (common, open, close). Extra cable required.
Pre-programmed Remotes – Includes two transmitters that are already programmed to the receiver, so your universal garage door remote control is ready to use straight out of the box.
Quick & Easy Installation – Most installations take less than 15 minutes.
Future Expansion – Easily add more transmitters to your universal garage door remote system at any time.

What’s in the Box

1 x Receiver with 3m pre-wired cable
1 x Plug-in power supply
2 x Pre-programmed 868MHz transmitters

The receiver can be connected to your existing bell push or start button terminals using just 2 wires. Three metres of pre-wired cable is provided
Supplied with a plug in power supply, or it can be powered off the existing control board using 12/24Vdc
Supplied with 2 pre-programmed transmitters and full instructions
Please note the receiver is designed for internal use only
200 transmitter memory
50 metre transmission range
Can control up to 2 doors or a single door with separate up and down buttons. See manual for more details.

📄Manual

▶Programming tutorial

▪ Garage door isn't operating when pressing the remote

Answer:

If the receiver is clicking when the remote is pressed:

The system is working. Check no wires have come out inside the receiver. Check you connections to the garage door controller. Refer to the manual of the garage door controller.

If not:

Check there is power to the receiver.
Program the remote. You may need to program both buttons depending on your configuration.

▪ Remote won’t program

Solution:

Check the remote is compatible and looks identical to other remotes on the system.
Change the batteries, even if the LED is lighting up.
Refer to the receiver manual or follow the programming video tutorial.
If more than one remote won’t program, the issue is unlikely to be the remotes. Check there are no metal objects obstructing the receiver, extend the antenna if possible, and check its power supply.
If a new installation, test in a different location to determine if the issue is signal interference.

▪ Remote has stopped working / intermittent

Solution:

Change the batteries, even if the LED is lighting up.
If more than one has stopped working at the same time, check there’s power to the receiver. If you can hear the receiver relay clicking when you press a remote, then the system is working. The issue is probably with the garage controller or the wiring between the two. Contact your installer or maintenance company.

CFOB, FOB2-M, FOB2-M-S