EL00PM-RAD Post Mount Magnetic Vehicle Detector

Brand: AES Global

From £348.60 ex VAT

Above ground vehicle detector

The above ground Magnetic Vehicle Detector is a side on vehicle detection solution ideal for driveways unsuited to traditional ground loops or for ease of installation with no cutting into the road surface and no cables run back to the gate controller.

Mount to a post at the side of the driveway 600mm from the floor with the e-Loop facing the desired detection area.

The post-mounted wireless magnetic vehicle detection system uses military grade magnetometer sensors. With added radar confirmation, to detect the presence and movement of vehicles at a range of up to 3 metres. Offered exclusively with presence mode capability, the Post-Mounted e-Loop can act in both presence mode and exit mode (use of diagnostic tool needed).

When the e-Loop detects a vehicle it transmits a signal to the transceiver in the gate box which opens the gate.

Options

Features:

High-security 128-bit encryption.
Compact profile – 176mm H x 70mm W x 30mm D.
2 x 1.5 V 3000ma AA Lithium Batteries.
Up to 2 years of battery life.
IP68.

▪ e-Loop will not code to the transceiver

Answer:

Ensure loop is held directly beside transceiver for pairing process, initiate code process on transceiver, this should automatically detect loop and successfully pair if close enough. For commercial or inground loops: these can be paired in close proximity or in location by using pairing method 2.
(See video linked below.)
https://youtu.be/3FcmmoQKl2Q?t=23

▪ What is the maximum distance between the e-Loop and transceiver?

Answer:

The loop can be placed up to 50M away from the transceiver using supplied antenna, ensure a clear line of sight between loop & transceiver. Please note: housing the transceiver in a metal enclosure or close to high voltage power lines could reduce the transmission range. If you are having issues, please try house the transceiver in its own separate enclosure or try an external antenna.

▪ How do I reset an e-Trans50?

Answer:

Press and hold the code button for approx. 11 seconds until you see all 3 LED’s on transceiver flash up. This will clear the memory of the transceiver, you can then go ahead and start the pairing/coding process with your loop/s.
(See video linked below.)
https://youtu.be/wPtsT1zbzAU

▪ I have paired the loop, but it is not triggering the gate/barrier

Solution:

Test by placing metal object or driving vehicle over loop, on the transceiver check if Red/RX LED comes on while doing so, this will indicate the loop is triggering and signal sent to transceiver firstly. If gate is not triggering, double check wiring from gate motor, you can also test & prove relay is changing state by using a multi-meter. If still having issues, please call technical support to discuss further. +44 28 8639 0693

▪ Can I pair more than one e-loop to a transceiver?

Answer:

Yes, up to 4 can be paired.

Weight	2 kg
Dimensions	176 × 70 × 30 mm
Options	EL00PM-RAD E-LOOP Only, EL00PM-RAD-K E-LOOP With ETRANS-50, EL00PM-RAD-KLT E-LOOP With ETRANS-200, EL00PM-RAD-KT E-LOOP With ETRANS-100, EL00W-RAD Wired Loop with 20m Cable