Gilgen FD10 Door Operator

It has been TÜV design-type tested on the basis of one million cycles.

• Compatible with single/two-leaf doors and interlock accesses
• Controlled, spring-actuated closure with motor assistance
• The drive mechanism has a built-in travel stop
• The integrated load function guarantees resistance against high wind loads
• Freely selectable Full Power and Low Energy functions in a single drive mechanism
• Assisted-opening option, with servo function
• Terminals for connecting accessories such as locks, security/safety elements or operating controls
• Voltage-free outputs for acknowledgements to, for example, the building management system (via relay PCB)
• Simple to set up and operate via the integrated graphic display screen
• TÜV approved and complies with the pertinent standards and requirements (e.g. EN 16005, DIN 18650)

The operator must be installed by a qualified engineer to EN16005. The purchaser and installer are responsible for conducting a risk & fire assessment and ensuring the standards are met.

• Power transfer: Standard rods (pushing function) | Sliding rods (pushing and pulling function)
• Weight of drive system: 8.2kg
• Protection rating: IP 20
• Ambient temperature: -15 to +50 °C
• Operating voltage: 230 VAC (+10/-15 %), 50 Hz, 10/13 A
• Power consumption of drive system: max 350 W
• Rated motor capacity: 100 W
• Stand-by consumption: 4 W
• Power supply, external user 24 VDC (±10 %), 1,4 A
• Lintel depth standard rods: max. 250 mm
• Lintel depth sliding rods: -50 / +150 mm
• Opening speed: max. 40°/s
• Closing speed: max. 40°/s
• Relative humidity: max. 85 %
• Output shaft torque: permanent max. 56 Nm | short max. 165 Nm

📄Datasheet

📄Mounting and operating instructions